This guide will show you how to install the deck and belt on your Vision Fitness T9600 Treadmill. Please follow the instructions carefully to avoid any damage to your treadmill.
Checkout this video:
Introduction
This article will show you how to install the deck and belt on your Vision Fitness T9600 treadmill.
Tools and Materials Needed
In order to install the deck and belt on your Vision Fitness T9600 Treadmill, you will need the following tools and materials:
-Treadmill
-Deck
-Belt
– installation instructions.
Before beginning the installation process, make sure that you have all of the necessary tools and materials. Once you have everything you need, follow the instructions below to install the deck and belt on your treadmill.
Step-by-Step Instructions
To install the deck and belt on your Vision Fitness T9600 treadmill, follow these steps:
1. Unfold the treadmill deck and place it on a firm, level surface.
2. Locate the two deck support brackets (one on each side of the deck) and insert them into the corresponding holes in the frame.
3. Insert the front roller assembly into the front of the deck and secure it with the bolts provided.
4. Place the treadmill belt on the deck, making sure that the arrows on the belt are facing in the correct direction.
5. Position the rear roller assembly at the back of the deck and secure it with bolts. Be careful not to overtighten these bolts, as this can damage the treadmill belt.
6. Once everything is secure, raisethe deck into its upright position and plug inthe power cord.
Tips and Tricks
Here are some tips and tricks to help you install your deck and belt on your Vision Fitness T9600 Treadmill.
– First, make sure that the area where you will be working is level and clean. You don’t want anything to get in the way while you are working.
– Next, locate the allen wrench that came with your treadmill. You will need this to loosen and tighten the bolts on the deck.
– Now, it’s time to put on the belt. Start at one end of the belt, and slowly work your way around the deck, making sure that the belt is tight and centered as you go.
– Once the belt is in place, use the allen wrench to tighten down the bolts on the deck. Be sure not to over-tighten them, or you could damage the deck.
– That’s it! You’re now ready to use your new treadmill.
FAQ
How to Install Deck and Belt on Vision Fitness T9600 Treadmill:
1. First, make sure that the deck is in the locked position by moving the red locking knob to the locked position.
2. Next, locate the two yellow plastic knobs on each side of the deck.
3. Insert the provided allen wrench into the hole in each knob, and turn clockwise to loosen.
4. Carefully lift the deck off of the treadmill frame.
5. Then, insert the new deck underneath the frame, making sure that it is flush with all four sides of the frame.
6. Once the deck is in place, insert the allen wrench into each yellow knob and turn clockwise to tighten. Make sure that both knobs are tight before proceeding to step 7.
7. Now it is time to install the new belt onto the deck. Start by threading one end of the belt through
the lower roller pulley (the smaller of the two).
8. Continue threading the belt around the larger upper roller pulley, and then around both of
the idler pulleys located on either side of the deck. At this point, you should have about 6”-8”
of belt hanging off of each side of the deck (this will vary depending on your individual treadmill model). If you need to adjust
the tension on either side of
Conclusion
Thank you for reading our Vision Fitness T9600 Treadmill installation guide. We hope this has been helpful in getting your machine up and running. If you have any further questions, please don’t hesitate to reach out to our customer service team.
